Calibration Micro Tsunami Source

1. Connect Power Sensor to 83620B
2. Connect 83620B to power divider
3. The 3rd connection remain the same

For min power at 20GHz the value suppose to be negatif value
- posted by rosli @ 11:12 PM

 
Technical Computing Software Depot Overview
- posted by rosli @ 7:12 PM

 
Li,

If there is power holes problem, first change the small coax cable and rerun the Autocal20G test.

rgds
Suresh N
R&D Engineer
Motorola Penang
- posted by rosli @ 8:53 PM

 
#6054 Temperature out ouf Spec (ALC problem aku rasa)
MA20 problem
#6057 Fail Cannot Set DUT PMYO FREQ (Test Nu 5) Suspect PMYO @ ALC problem
ALC problem
#4996 Tunggu Low Band Amp tak dak stok
Low Band Crack
#1113 Line Return ni aku dah confirm Low Band Fail hg tanya Pang kalau dia mai LB ada dengan dia

- posted by rosli @ 7:34 PM

 
The method to retest the 20GHz power is.
1. OFF NA and ON back
2. Type in serial no 101 in RMB. VERY IMPORTANT to type serial no as it initialize instrument control.
3. Then run the 20GHz power test.
Nescaya jika anak mengikut langkah ini hidup anak akan ceria.

- posted by rosli @ 4:50 PM

 
Apply to Microwave Tsunami (M2 & M3)
Check Board Header (Vee Program) after restart the NA
Run RMB [Source 20 Power]
if still fail Preset the Spectrum Analyzer

ALC information
BoardName = Source
Memort Type ID= 3
Harware ID = 12
Serial Number = [Open ALC case]
Firmware Revision = B
Board P/N = E836260001
CheckSum =[This info no need to enter]
Vendor Code = 23
Datecode = [Open ALC case]
Revision Code = 99
Option (Hex) = 0000 for M2 & 0001 for M1
Spare = 0000 [This infor no need to enter]
- posted by rosli @ 7:00 PM